Reset your PLC adapter Wi-Fi extender

Is the dLAN LED indicator of your Wi-Fi Extender PLC  adapter (or Wi-Fi Extender) red? It is probably not communicating properly with the PLC adapter connected to your b-box. You will have to reset your Wi-Fi Extender and PLC adapters, and then resync them.

Choose your PLC adapter Wi-Fi Extender (or Wi-Fi Extender). Does it have 2 or 4 LEDs?


Wi-Fi Extender with 2 LEDs

Wi-Fi Extender with 2 LEDs

Reset

  1. Using a paper clip, press the button under the Wi-Fi Extender for about 12 seconds. Your Wi-Fi Extender has been reset.
  2. Press the button under or on the side of the PLC adapter connected to your b-box for about 20 seconds. Your PLC adapter has been reset. You must now resync the Wi-Fi Extender and the PLC adapter.
    Press the button next to the cable entry port of one of the adapters
Reset a Wi-Fi Extender How to reset a Wi-Fi Extender?

Synchronization

  1. Unplug your Wi-Fi Extender and plug it in again close to your b-box. Wait 45 seconds.
  2. Press for 2 seconds on the dLAN button of your Wi-Fi Extender.
  3. Press for 2 seconds on the button under or on the side of the PLC adapter connected to your b-box. Wait until the dLAN LED indicator of the Wi-Fi Extender is lit solid white.
  4. Press the WPS light or WPS lightbutton of your b-box for 2 or 3 seconds until the LED indicator lights up.
  5. Press briefly on the dLANbutton of the Wi-Fi Extender.
  6. The Wi-fiindicator of the Wi-Fi Extender will blink for up to 2 minutes. When this indicator is white, the sync has been completed.
  7. When the LED indicators are stable, you can connect your Wi-Fi Extender again in its original place.
Wi-Fi Extender synchronisation How to configure a Wi-Fi Extender?

Wi-Fi Extender with 4 LEDs

Wi-Fi Extender with 4 LEDs

Reset

  1. Using a paper clip, press the button on the side of the Wi-Fi Extender for about 20 seconds.  Your Wi-Fi Extender has been reset.
    reset button
  2. Press the button under or on the side of the PLC adapter connected to your b-box for about 20 seconds. Your PLC adapter has been reset. You must now resync the Wi-Fi Extender and the PLC adapter.
    Press the button next to the cable entry port of one of the adapters

Synchronization

  1. Unplug your Wi-Fi Extender and plug it in again close to your b-box. Wait 45 seconds.
  2. Using a paper clip, press the button on the side of your Wi-Fi Extender for 2 seconds.
  3. Press for 2 seconds on the button under or on the side of the PLC adapter connected to your b-box. Wait until the dLAN LED indicator of the Wi-Fi Extender is lit solid green.
  4. Press the WPS lightor WPS lightbutton on your b-box for 2 or 3 seconds until the LED indicator lights up.
  5. Press theCPL or button on the  Wi-Fi Extender.
  6. The Wi-fi indicator of the Wi-Fi Extender will blink for up to 2 minutes. When this indicator turns green, the sync has been completed.
  7. When the LED indicators are stable, you can connect your Wi-Fi Extender again in its original place.

Did you find this helpful?

Thank you


More

Forum

Didn’t find an answer? Join our community where customers and experts help each other (in French).

Forum

Contact

Our advisors are at your disposal. Choose your contact mode.

Contact