The PLC adapter is the wireless solution that allows you to connect your TV Box to your b-box via the mains, wherever the b-box is located! This guide will help you carry out your initial basic setup. To do this, you have been supplied with two boxes, each containing one PLC adapter.
Connect the second PLC to the same room as the first PLC connected to the b-box
.
Press and hold the button on the side of the PLCs for 1 second (the order doesn’t matter). Once the configuration is complete, the indicator lights on both PLC adapters will remain steady and solid white. You can then move your PLC adaptor and proceed to step 5.
Check that the connections have been made correctly. If the problem persists, reset both PLC adapters by holding down the button on the side of the adapter for 12 seconds
until the Indicator light goes out. Unplug the PLC adapters from the power sockets and plug them back in, preferably in the same room, whilst you reconfigure them.
Press and hold the button on the side of both PLC adapters for 1 second
(in any order). Once reconfiguration is complete, the indicator lights on both PLC adapters will remain steady and solid white.
Flashing red
: device in deep sleep mode. Steady red
: connection problem. Blinking white
: configuration in progress or device in standby mode. Solid white
: device configured and connected.
Step 5
Connect the second PLC to the TV Box
Connect the second PLC adapter to a power socket and connect it to the TV Box using the Ethernet cable.
Step 6
Switch on the TV Box
Connect the TV Box’s power lead to the PLC adapter or to a multi-socket socket connected to the PLC adapter.