Skip to main content
Menu
View all guides

PLC adapters – Pack of 1 PLC adapter

Installation Guide
Step 1

Before you begin

With this additional PLC adapter, you can connect a TV Box to your b-box via the mains, no matter where the b-box is located! You must have already carried out the basic installation of at least two PLC adapters.

Installation type
Select the type of box you have.
Please make sure you have a b-box 3 or later.

Required components for the installation



Step 2

Configure the 2 PLCs

During configuration, connect the new PLC adapter to the same room as the one that has already been configured, near the b-box. Press and hold the button on the side of the PLC adapter that has already been configured for 1 second. The red indicator light on the front of the adapter should start flashing.
Within 2 minutes, press and hold the button on the side of the new PLC adapter for 1 second. The red Indicator light on the front of the adaptor should start flashing.
After a few seconds, the PLC indicator light should be steady and solid white. You can move your new PLC and proceed to step 3.
Check that the connections have been made correctly. If the problem persists, reset both PLC adapters by holding down the button on the side of each adapter for 12 seconds
until the Indicator light goes out. Unplug the PLC adapters from the power sockets and plug them back in, preferably in the same room, whilst you reconfigure them.


Press and hold the button on the side of both PLC adapters for 1 second
(in any order). Once reconfiguration is complete, the indicator lights on both adapters will remain steady and solid white.
Flashing red
: device in deep sleep mode.
Steady red
: connection problem.
Blinking white
: configuration in progress or device in standby mode.
Solid white
: device configured and connected.

Step 3

Connect the second PLC to the TV Box

Connect the second PLC to a power socket and connect it to the TV Box using the Ethernet cable.

Step 4

Switch on the TV Box

Connect the TV Box’s power supply to the PLC adapter or to a power strip connected to the PLC adapter.
If you have several sockets in a row, make sure you connect the PLC adapter to one of them and do not use the others, to avoid any interference.

Was this guide helpful?

Thank you for your feedback!

Do you have any suggestions for us? What did you like?

We are sorry to hear that!
Your feedback matters to us!

What are you looking for?

Your feedback has been sent to our teams.